Where the drain plug is located?
The drain plug is a large nut or plug located under the oil pan at the bottom of the engine. If you can’t reach your oil drain plug easily, you’ll have to either crawl under your car to reach it or jack up the car.
How many quarts of oil does a John Deere lawn mower take?
The John Deere 102 mower has a recommended oil capacity of 1.5 quarts. The manufacturer also recommends the use of SAE oil such as 5W-30, 10W-30 or 15W-40, based on air temperature where you will be using the mower.
How do you change oil in John Deere Gator?
How to Change the Oil in a John Deere Gator TX Utility Vehicle. John Deere recommends changing the oil and filter after the first eight hours of operation, then every 100 hours — or at least once a year. Change the oil and filter more often if you make a lot of short trips, run the vehicle in dusty conditions, or often operate it at low or slow speeds.
What kind of oil does a John Deere lawn mower use?
John Deere prefers that 10W-30 be used in all its gasoline-powered engines, including those on riding mowers. The “W” indicates that the oil was tested at low air temperatures. A 10W-30 weight engine oil is viscous even at temperatures as low as negative 4 degrees Fahrenheit .
What is the engine oil capacity for a John Deere?
Recommended Capacity. The recommended capacity is the amount of oil that the manufacturer specifies so the engine operates efficiently. The John Deere 102 mower has a recommended oil capacity of 1.5 quarts. The manufacturer also recommends the use of SAE oil such as 5W-30, 10W-30 or 15W-40, based on air temperature where you will be using the mower.
How to change the oil in a John Deere tractor?
Take Oil Plug Out. Grab a 5-gallon pale and 2 inch and eight inch wrenches to take the drain plug out.
How much oil does a 2004 4Runner take?
The base 4.0L V6 engine in the 2004 Toyota 4Runner takes 5.5 quarts of synthetic type 5W30 oil. The optional 4.7L V8 engine uses 6.6 quarts of synthetic oil in a 5W30 viscosity.
How do you reset the maintenance light on a 2004 Toyota 4runner?
To reset the maintenance light for the 2004 toyota 4runner, turn the ignition switch to the “on” position. Set the odometer/trip display to “odo” mode. Now turn the ignition switch to “off” position. Depress and hold the trip meter “reset” button while turning the ignition switch to the “on” position.
How much oil does a 4.7 L V8 take?
SAE 5W-30 is preferred. Capacity: 6 quarts. . . . (with filter)After refill check oil level.
How do you reset the maintenance light on a 2004 Toyota 4Runner?
Does Toyota 4Runner require synthetic oil?
Every Toyota 4Runner oil change is performed by our factory-trained mechanics and includes a multi-point inspection, as well. For example, 4 cylinder passenger cars take less oil, and customarily use conventional oil, compared to a vehicle with a high-performance V-8 engine, which may require full synthetic motor oil.
What size is oil drain plug?
Oil Drain Plug Standard M14-1.50, Head Size 17mm.