How do I open my Philips blender?

There is an easy way to open the jar lid of your Philips Mini Blender. Hold the jar with both hands as shown in the image below. After this, use the thumbs to push up the protrude part of the lid. The lid will open without effort.

Why is Blender not spinning?

Tightening the Drive Stud: If the motor operates well, but the blade in the blender jar doesn’t turn as it should, the problem may be the drive stud. The most frequent cause is a loose drive stud. To tighten the drive stud: The other end of the drive shaft will protrude from the bottom side of the motor.

Can a blender be repaired?

Dull blades from blending lots of ice or other hard foods can also cause stress on the motor, sometimes resulting in a burning smell. Replacing the blade assembly is an easy repair you can complete yourself. Make sure your blender is unplugged before beginning this repair.

Why did my immersion blender stop working?

One of the most common problems with hand blenders is blender not working completely. This could be a result of an issue with the fuse. To check the fuse, you may first need to disassemble the unit till you reach the inner body where the fuse is located. If the reading is high, you may need to replace the fuse.

Where are Braun hand mixers made?

Braun MultiMix Hand Mixer Braun makes great razors, and amazingly they continue to manufacture them in Germany.

Why is my Philips blender not working?

Your blender will not start working while the safety lock is locked. Please put the blender jar in the correct position so the built-in safety lock is unlocked. For this, make sure you have turned the blender jar, mill, chopper or tumbler in clockwise all the way until a “click” sound is heard.

Why did my blender suddenly stopped working?

A burned-out fuse will cause your blender not to turn on. To check if the fuse is blown, remove the base cover and inspect either the motor switch or circuit board for a blown fuse. To check if the fuse is blown, remove the base cover and inspect either the motor switch or circuit board for a blown fuse.