How do I log into my Linksys WRT54G?

What default IP Address, username and password are used to log in to the router’s web-based setup page? The default IP Address is 192.168. 1.1. On the log in window, leave the username blank and the password is “admin”.

What is the default login for Linksys router?

admin
The router’s default password is “admin” as for the username, just leave the field blank. IMPORTANT: Make sure that the Power LED of the router is blinking when you press the Reset button.

What is the Linksys WRT54G router?

The Linksys WRT54G Wireless-G Broadband Router is a 3-in-1 residential gateway device. It acts as a wireless access point which lets you connect your wireless computers and devices to it without using wires. It also serves as a built-in 4-port full-duplex 10/100 switch to connect your wired devices to it using Ethernet cables.

What is the difference between the WRT54G-TM andwrt54gs?

According to the Linksys WRT54G series, the WRT54G-TM is nothing but a renamed WRT54GS v3.0. Because these models have additional RAM and FLASH they do not suffer from the constraints of the WRT54G and WRT54GL series and can run all versions of OpenWRT as of 11/1/2014.

How do I connect my WRT54G to my computer?

Connect the yellow wire (12 volts) to the positive side and one (or both) of the black wires to the ground. Now connect this to a spare hard disk power connector on a PC power supply and your WRT54G will power up. You can also use a 12 volt lead acid battery (e.g. a car battery) to run the WRT54G.

Does the WRT54GL have hardware or software flow control?

Neither of the ports use hardware flow control, you need to use software flow control instead. Other routers may have similar connections. These two TTL serial ports on the WRT54GL router can be used as standard Serial Ports similar to the serial ports you may have on your PC.