Why does my Dodge Charger feel sluggish?

Defective Fuel Pump: The fuel pump pulls the fuel from the gas tank to the engine via the fuel lines. If the pump stops working, malfunctions, or becomes clogged, it will not supply enough fuel to the injectors. This can cause the vehicle to accelerate slowly, or even sputter and stall, especially at high speeds.

Are there any recalls on a 2009 Dodge Charger?

CHRYSLER IS RECALLING 20,283 MY 2006-2009 CHARGER AND MAGNUM VEHICLES BUILT WITH THE POLICE PACKAGE EQUIPPED WITH COLUMN SHIFTER. THE GEARSHIFT CABLE MAY BECOME DISENGAGED FROM THE STEERING COLUMN MOUNTING BRACKET AND CAUSE AN INCORRECT TRANSMISSION GEARSHIFT POSITION DISPLAY.

What are common problems with Dodge Chargers?

Most Common Problems of the Dodge Charger

• Transmission Shudders During Gear Shifts.
• Power Windows Stop Working.
• Opera Lighting Ceased Functioning.
• Check Engine Light for Bad Thermostat.
• Difficult to Fill Up with Gas.
• Cruise Control Will Not Shut Off.
• Sudden Loss of Power on AWD Vehicles.
• Fuel Leaks on SRT.

How do I get my Dodge Charger out of limp mode?

In the event of a momentary problem, the transmission can be reset to regain all forward gears by performing the following steps:

1. Stop the vehicle.
2. Shift the transmission into PARK.
3. Turn the engine OFF.
4. Wait approximately 10 seconds.
5. Restart the engine.
6. Shift into the desired gear range.

Why does my Dodge Charger jerk?

When a fuel pump begins to fail, it may struggle to consistently deliver the correct amount of the fuel to the engine. The fuel pump may dramatically increase pressure while failing, creating a jerking or surging sensation. Your vehicle may also be sluggish and struggle while driving uphill or towing.

Is a 2009 Dodge Charger a good car?

2009 Dodge Charger Overview As with many other Dodge vehicles, reviewers had an issue with the Charger’s interior quality, but they found the cabin to be spacious. The Charger offers all-wheel drive on two trims. The Charger lags behind other 2009 large cars with a below-average safety score.

What is the average lifespan of a Dodge Charger?

The Dodge Charger can last up to 250,000 to 300,000 miles with proper maintenance and care. If you average 15,000 miles per year like the regular American driver, you can get up to 13 to 20 years of service from the Charger.

What causes limp mode Dodge Charger?

If Your 2006 Dodge Charger has gone into limp mode it usually is caused by a problem that was detected by Your vehicle’s ECU. There will often be a check engine light on at the dash as well. If it is a simple thing, like a failed sensor, then You can clear the code and it will take the vehicle out of limp mode.

How do you reset a 2008 Dodge Charger?

Dodge Charger Oil Light Reset Procedure for Model Years 2008-2015:

1. Turn the car in the on position.
2. Use the up/down arrows on left side of steering wheel to find -Vehicle Info-
3. Then use the left/right arrows to find -Oil Life Remaining-
4. Press and hold the OK button until oil life returns to 100 percent.

How do you calibrate a throttle body on a Dodge Charger?

Throttle calibration can take care of these.

1. Insert ignition key and turn to “ON” (not start).
2. Wait for all idiot lights to go out.
3. Slowly depress the accelerator pedal all the way to the floor.
4. Slowly release the accelerator pedal until it’s all the way back up.
5. Turn the ignition key to “OFF”.

What causes a camshaft position slow response code?

If any of the oil pump connections become degraded or passageways become clogged, the reduced oil pressure may trigger a camshaft position slow response code. How serious is the P000A code?

What does Bank 1 mean on a camshaft position slow response?

All our repairs are backed by our 12-month / 12,000-mile warranty. This code is known as ‘A’ Camshaft Position Slow Response Bank 1. You may also see a 00010 fault along with this code, which indicates that the problem is in Bank 1.

What’s the p000a code for a camshaft position slow response bank?

P000A is a diagnostic trouble code (DTC) for “”A” Camshaft Position Slow Response Bank 1″. This can happen for multiple reasons and a mechanic needs to diagnose the specific cause for this code to be triggered in your situation. Our certified mobile mechanics can come to your home or office to perform the Check Engine Light diagnostic for $114.99 .

How to program an additional key to a Chrysler key?

Here are the steps you should take to program an additional Chrysler key: insert your first original key – One of the two keys that currently you are able to start the car with into the ignition cylinder. Turn the ignition cylinder to “ON” position for five-ten seconds and after to “OFF” position.