Why Does My Brother sewing machine thread keep breaking?

Why Does My Brother sewing machine thread keep breaking?

The upper thread tension could be set too tight. Set the tension to the best thread tension setting or less. Make sure the spool of thread is installed correctly using the correct size spool cap for the size of spool. Check that the bobbin is wound so that it about 80% full and that the thread is evenly wound.

What causes top thread to break in sewing machine?

When the tension is set too high, the thread is stretched greatly from the spool to the needle, causing great tension in the thread and thus the upper thread breaks during sewing. You can reduce the thread tension to see if it improves. Working with a suitable tension can prevent upper thread from breaking when sewing.

What is the remedy when the upper thread breaks?

Remedies: Check the threading order and thread correctly. Adjust the tension disc. Replace blunt or bent needles.

How do I fix the tension on my Brother sewing machine?

Adjusting the thread tension

  1. Sew trial stitches using thread and scrap fabric that are the same as those used for your project.
  2. Check the sewing results. If necessary, adjust the thread tension.
  3. Adjust the thread tension until the proper tension is achieved while checking the sewing results with trial sewing.

What tension should my sewing machine be on?

The dial settings run from 0 to 9, so 4.5 is generally the ‘default’ position for normal straight-stitch sewing. This should be suitable for most fabrics. If you are doing a zig-zag stitch, or another stitch that has width, then you may find that the bobbin thread is pulled through to the top.

How do you adjust upper thread tension?

Changing Bobbin Tension You should see a small screw on the flat/closed side of the bobbin case. Turning the screw a tiny bit counterclockwise will loosen the bobbin tension; turning it clockwise will tighten the tension.

What is the causes and remedies of upper thread breaks?

Needle Thread Breakage

Cause Remedy
Broken check spring. Replace and adjust.
Sharp edges on throat plate, hook point, needle guard, bobbin case, needle groove or eye. Polish rough edges and replace if necessary. Replace the needle being used with a higher quality needle.

What number should tension be on sewing machine?

Why is my top thread so tight?

If the bobbin thread was incorrectly threaded, the upper thread may be too tight. If the upper thread was incorrectly threaded, the upper thread may be too loose. 4. To increase the upper tension – increase the tension setting or turn the knob to the right.

What tension should I use for cotton?

Cotton requires a moderate tension setting, usually between three and four.

Why does the upper thread keep breaking on my sewing machine?

Why does the upper thread keep breaking? There could be several reasons why the upper thread keeps breaking. The upper thread could be installed incorrectly. Rethread the machine according to the instructions. For details, refer to ” Upper threading “. The upper thread tension could be set too tight.

What should I do if my sewing machine thread is loose?

Check the upper thread. – Check to make sure that the upper thread was threaded properly through the thread path and that it is not tangled. If so, remove the thread completely from the machine and re-thread it. – Make sure you are using the correct size spool cap for the size of the thread spool.

How to avoid interrupted thread breaks?

Remember, whenever you sew, always focus on the thread tension by taking the thread type and fabric into account. You can easily escape from interrupted thread breaks if you maintain proper tension in both the upper and lower thread strands.

Why is the tension on my sewing machine too low?

The tension could be too tight or too loose. – Set the tension to the basic thread tension setting or adjust the tension manually. If your machine is an embroidery machine, check that the tension is set at 5. The tension should be adjusted when you change fabric or thread type.