What does CE mean on a washing machine?
The CE error code indicates that there has been an over-current in the electrical circuit of the motor. It is caused by a short circuit, loose connection, ground fault or power surge. To fix this: Unplug the washer for 10 seconds.
How do I reset my Whirlpool Calypso washer?
Your Calypso washer does not have a “reset” button. If the outlet works then the failure is likely the machine control board. You did not state if “PF” displays when you plugged the washer back in. It should have displayed “PF” for power failure when plugged back in.
How do I clear the error code on my Whirlpool washer?
To remove the code, press pause or cancel button twice and the power button once. If the code is still displayed, unplug the washer or disconnect the power for one minute. Items were detected in the washer during the Clean Washer cycle. Remove items from the drum and restart the Clean Washer cycle.
What does CE mean on dishwasher?
CE – The control panel is unable to communicate with the rest of the dishwasher. Turn off the dishwasher and try to start it again.
What does CE mean on Samsung washing machine?
Samsung Washing Machine Error Codes
| Error Code | Cause |
|---|---|
| CE, E8 | Cooling Error (temperature of water has not dropped below 55°C in 30 minutes after the washer cooling operation) |
| dE, Ed | Door Open Error (door not closed correctly/properly) |
| dE1 | Door Lock Switch Error |
| dE2 | On/Off Switch Error |
How do you reset the code on an LG washing machine?
In most cases, you can simply reset the washer to solve the problem. Unplug your washer before pressing and holding the Start/Pause button for approximately five seconds. Plug it back in and set the washer to a rinse-spin cycle to see if the code has cleared.
What does E10 mean on washing machine?
Washer dryer displays error message E10, C1 or emits 1 beep / 1 flash. It indicates a problem with not taking in water, not taken in enough water or problems with the drain.
How do I fix 5UD error on Samsung washer?
In most cases, SUD or 5UD means your Samsung washer has detected too many soap suds or too much foam during a wash cycle. When the washer detects too many suds, it displays the SUD or 5UD error code while it tries to fix the problem by adding more water and pausing the wash cycle to allow the suds to dissipate.
How do you fix UC error on Samsung washer?
How to fix the problem
- Disconnect the appliance by pressing the appropriate button and taking the cord out of the socket;
- Wait 5 minutes;
- Plugin and restart the washing machine.
How do I troubleshoot a CE error on my power cord?
Check the resistance values between the serial communications pins with the connectors in place. Make sure the harness does not have a bad connection. Check the quick disconnect at the motor terminal. The drive motor must be hooked up properly or a CE error will occur.
How do I clear the error code on my pump?
The pump is cycled in drain mode for 30 seconds on, 30 seconds off until the overfill switch resets or power is discontinued to the unit. Press STOP/CANCEL to clear the display. This error code is displayed if the control failed to save cycle information during a power failure. This does not generate an error code beep.
What does the error code LF mean on a whirlpool washing machine?
This error code is displayed if the control failed to save cycle information during a power failure. This does not generate an error code beep. Press STOP/CANCEL to clear the display. If the water fill time exceeds ten (10) minutes, the water valves are turned off and “LF” is flashed.
0