What causes a furnace blower to stop working?

What causes a furnace blower to stop working?

Sometimes the furnace blower isn’t working because the thermostat is set too low. Over the summer or more recently, someone may have accidentally lowered the thermostat temperature. Perhaps there is a wiring issue causing the blower to stop working. The motor might have a problem and requires service.

Is there a reset button on a furnace blower motor?

Locate the reset button on the furnace and press it to reset the furnace. It is usually located inside the blower compartment on the side of the blower motor. Be cautious as the housing may be hot. If the button is popped up, press it down.

What is the fault code on a carrier motor blower?

Carrier motor blower fault code 41. Carrier motor blower fault code 41. Blower not correct speed detected. Carrier infinity. New Carrier Infinity heat pump installed past January is giving a 41 error code.

What does code 41 mean on a carrier Infinity blower?

Carrier infinity fault code 41 -furnace : Blower Motor Fault: 41 codes may show up in fault history, but if system is operating properly, this can be ignored: 42: Inducer Motor Fault (VS Inducers Only) 43: Low-Heat Pressure Switch Open While High-Heat Pressure Switch Closed : 45: Control Circuitry Lockout

What does error code 41 mean on a Bryant furnace?

Error code 41 on a Bryant or Carrier furnace is the notice for a blower motor fault. Short of replacing the blower, what do I do to fix it? Error code 41 can happen when the blower fails to reach the 250 rotations per minute threshold. In that case, it could simply be a matter of adding oil to the blower motor.

What are some of the error codes for the Infinity carrier?

Carrier infinity fault codes – Fan Coil Generated error codes (commonest) Flash error code Fault description 37 Heater output sensed On when not energiz 41 Blower Motor Fault 44 Motor communication Fault 46 Brown Out Condition