How much does a gear vendor cost?

At about 2600 dollars (depending on model) the GEAR VENDORS is not the cheapest way for you to get overdrive but is by far the best. A Gear Vendors will handle more horsepower, deliver bigger performance gains, give you guaranteed trouble-free performance, and install easier than any other overdrive available.

What does a gear vendor do?

The Gear Vendors unit gives you two options when it comes to driving; the first is to put it on the automatic overdrive mode that can be programmed to shift into overdrive at any speed you set. The second option is to switch the Gear Vendor into the manual mode and begin gear splitting.

How much do Gear Vendors weigh?

Net Weight 32-46 lbs depending on application hardware.

How do you shift a gear vendor overdrive manual transmission?

If you are boulevard cruising or already rolling in 1st and you want to nail the throttle and grab 1st-over , just hit the button as soon as you stomp the gas and the overdrive will shift at a very appropriate time based on driveshaft speed.

Is it safe to drive in overdrive?

It’s not bad to drive with overdrive off and does no harm to the transmission. However, you will get worse fuel economy and have more noise at high speeds. There’s really no reason to leave it off unless you need to ascend or descend a steep hill. You can turn overdrive on or off at any time or speed.

How did overdrive work?

An overdrive consists of an electrically or hydraulically operated epicyclic gear train bolted behind the transmission unit. It can either couple the input driveshaft directly to the output shaft (or propeller shaft) (1:1), or increase the output speed so that it turns faster than the input shaft (1:1 + n).

What is a gear splitter?

The splitter is a THIRD set of gears behind the main tranny and the range gearset. It is pneumatically operated, and the gears “float in” when you goose the foot feed. 147 views. Pavithra Bethina. Large or heavy trucks have three types of transmissions: range, splitter and range- splitter.

How much HP can a stock TH350 handle?

The Stage 1 TH350 is rated up to 450 hp. Those seeking something a little stronger can check out the Stage 2 version (PN PA35102) that holds 550 hp and retails for $1,500 with a real world street price of $1,175 from most vendors.

Is a 700R4 longer than a TH350?

Length And Weight The TH350’s case length is 21 5/8 inches. Depending on the tail shaft housing, its overall length can either be 27 5/8 or 30 5/8 inches. The 700R4’s case length is 23 3/8 inches and its overall length is 30 3/8 inches. The TH350 weighs 120 lbs., while the 700R4 weighs 155 lbs.

How do I contact Gear Vendors?

Just e-mail us today or should you wish to talk to one of our application engineers just call 1-800-999-9555. GEAR VENDORS, INC. 1717 North Magnolia Avenue, El Cajon, CA 92020 We use cookies to ensure that we give you the best experience on our website.

What is gegear vendors?

GEAR VENDORS is one of few products that can work both sides of this equation for real performance gains as well as consistent fuel consumption reductions.

Where is gear located in El Cajon CA?

GEAR VENDORS, INC. 1717 North Magnolia Avenue, El Cajon, CA 92020 We use cookies to ensure that we give you the best experience on our website. If you continue to use this site we will assume that you are happy with it.

What vehicles can Gear Vendors make a kit for?

GEAR VENDORS application engineering makes a kit for virtually all rear wheel drive and 4 wheel drive vehicles. So should you not find your specific vehicle listed in the following pages, rest assured that we can provide a unit which is designed for your application.