How do you reset the SRS light on a Honda Accord?

How do you reset the SRS light on a Honda Accord?

How to Reset a Honda Accord SRS Light

  1. Straighten out a paperclip.
  2. Pull down on the fuse panel cover under the steering column with your fingers to remove it.
  3. Locate the small yellow plug in the fuse panel.
  4. Unplug the power connector from the fuse panel.

How do I get my SRS light to go off?

Conclusion – How to Reset Airbag Light

  1. Turn your ignition on and off.
  2. Restart your vehicle and do a test drive.
  3. Examine the passenger airbag switch.
  4. Inspect whether seat belts are fastened or working correctly.
  5. Verify that the passenger seat sensor is not applied.
  6. Use a scanner with an SRS or airbag light reset option.

Why is the SRS light on in my 2002 Honda Accord?

The supplemental restraint system (SRS) light should come on momentarily when the ignition is turned on. It should then go out. If the light stays on continuously, there is a problem in the SRS system. The cause of the light could be anything from a failed clockspring to a faulty control module.

How do you turn off the SRS light on a 2003 Honda Pilot?

By the driver’s left foot on the sidewall you will see an uncovered fusebox. There, you will find a yellow connector (very similar to your home computer internet wire). Its the only yellow connector there. 4-) the SRS Light will come on for 6 seconds, then go off.

How do you turn off the airbag light on a 2003 Honda Accord?

Go to the front of Your vehicle and disconnect the positive terminal from Your battery. When You note that the srs light has reappeared, go back to the battery and re-attach the terminal. This should reset the airbag light.

How do you reset the SRS light on a 2003 Honda Odyssey?

Place the key into the ignition and turn it on, but don’t allow the engine to turn over while still holding the wires together. Watch as the SRS light blinks on then turns off. Separate the wires right away and the SRS light will turn back on.

What is SRS code for Honda?

If your Honda airbag light remains on, it most likely means that the Supplemental Restraint System (SRS) has detected a problem with the airbag system. When your Honda airbag system functions properly, the airbag light comes on when you turn on the ignition but should turn off once you start the engine.

What causes SRS light on Honda Accord?

Seat Belts. Safety belts are still the most important safety feature in the event your Accord crashes.

  • Seat Sensors.
  • Airbag (No Response) If the Accord’s SRS system is not getting a response from one of the airbags,it’ll turn the SRS light on until the problem has been fixed,…
  • Sensors.
  • Not Reset After Deployment.
  • Can the OBD reset the SRS light?

    There are two ways to reset the SRS light: with an SRS scanner and manually. The SRS Light can be reset with an OBD2 Scan Tool. When using an SRS scanner, there are a few steps to follow. Step #1 – Find the fuse-cover and take it off. Step #2 – Fit the scanner in the port.

    What does the SRS light mean on a Honda Accord?

    What is the SRS light on a Honda Accord? The SRS light is a warning light for your supplemental restraint system (airbags). An SRS light means that there is a problem in the system. The first thing I would check is the fuse for the SRS unit.