How do I setup my HP ProCurve switch?

How to: Configure a HP ProCurve switch

1. Step 1: Connect your serial connection.
2. Step 2: Conenct PuTTY.
3. Step 3: Get the IP address.
4. Step 4: Set time server.
5. Step 5: Set SNMP community info.
6. Step 6: Launch the web GUI.
7. Step 7: Configure basic info.
8. Step 8: Create VLANs.

How do I reset my HP managed switch?

To execute the factory default reset on the switch, perform these steps:

1. Using pointed objects, simultaneously press both the Reset and Clear buttons on the front of the switch.
2. Continue to press the Clear button while releasing the Reset button.
3. When the Self Test LED begins to blink, release the Clear button.

How do I factory reset my HP ProCurve 1800 24G?

How do I reset factory defaults on the ProCurve 1800 Series Switches?

1. Remove the power cord from the back of the switch.
2. Connect port 1 to port 2 on the front panel, using a standard network cable.
3. Reconnect the power cord to the rear of the switch.
4. Wait at least 40 seconds before disconnecting port 1 from port 2.

How do I log into my ProCurve switch?

Log into your ProCurve using SSH or Telnet. Select Run Setup in the menu either by hitting 8 or using the arrow keys then hitting enter. Using the arrow keys, select Logon Default. Hit space to change Logon Default to CLI.

Where is the IP address on a HP ProCurve switch?

A switch should have a web interface and a telnet interface. Another approach would be to use the arp command to find its IP address from the Mac address (which should be physically labeled on it somewhere).

How do I enable Web access on my HP switch?

To enable web login, log in to the device via the console port, and perform the following configuration: • Enable HTTP or HTTPS service • Configure the IP address of the VLAN interface • Configure a username and password The device supports the following web login methods: • HTTP login: • HTTPS login: The following …

What is the default username and password for HP ProCurve Switch?

The default username for first time configuration is admin, no password is required.

How do I reset my HP ProCurve 2510 to factory settings?

How to reset a ProCurve 2510-24g to default settings

1. Press in both the Clear and Reset buttons (tiny buttons on the left edge)
2. Release the Reset button after the port lights come on (~2 seconds)
3. When the Self-Test LED starts flashing (to the left of the Clear and Reset buttons), release the Clear button.

How do I reset my HP ProCurve 2510 24?