How do I reset my warmup thermostat?

Press and hold the Main Button and, using a pointed device, press and release the Reset Button on the back of the thermostat. After 5 seconds release the Main Button on the front of the thermostat.

How do I turn off warmup underfloor heating?

The button on bottom of the 3IE (button 7) is the power button. You can turn off your thermostat and Warmup underfloor heating system by holding down this button for 3 seconds. You can turn it on again by holding it down for another 3 seconds.

How do you wire a thermostat to a blower?

Locate the “G” terminal, which controls the blower operation from the thermostat, on the board. Connect the green low voltage wire to the “G” terminal and put the access panel back on the front of the furnace. If no green wire exists you may need to pull a new thermostat wire from the furnace to the thermostat.

Does Tado work with underfloor heating?

With tado° Smart Thermostats, you can also control your water-based underfloor heating. Simply set your ideal temperature using your voice assistant, or control your heating from anywhere with the tado° app.

Can hive work with underfloor heating?

Hive supports wet underfloor heating systems but does not currently support electric underfloor systems. The heat produced from underfloor heating ensures an even distribution of heat in rooms so it is one of the most energy efficient ways to heat your home.

How do I reset my underfloor heating thermostat?

How do you reset underfloor heating?

Below are the instructions on how to reset the controller: Keep the Mode and i buttons on the underfloor heating controller pressed simultaneously for at least 10 seconds. After 4 seconds the controller changes over to test mode. Continue to keep the button pressed until the LED flashes yellow.

How do I install a 4ie thermostat?

The 4iE and its power supply should be isolated from the mains supply throughout the installation process. Pack Contents Mounting/Positioning 4 Loosen both screws at the bottom of the 4iE and remove the Back Plate. Install square 2 3/ 4 ” deep back box with a single mud ring (also called plaster ring) in your preferred thermostat location. 4iE

How do I install a 4ie back plate?

Install square 2 3/ 4 ” deep back box with a single mud ring (also called plaster ring) in your preferred thermostat location. 4iE Step 1 – Install Back Plate 1 2 Before making any permanent fixtures Warmup recommends identifying your preferred location for the 4iE. It should be located in an area with good ventilation.

Where should the 4ie heater be located?

1 2 Before making any permanent fixtures Warmup recommends identifying your preferred location for the 4iE. It should be located in an area with good ventilation. It should not be beside a window/door, in direct sunlight or above another heat generating device (e.g. radiator or TV).

Where should I place my 4ie?

Before making any permanent fixtures Warmup recommends identifying your preferred location for the 4iE. It should be located in an area with good ventilation. It should not be beside a window/door, in direct sunlight or above another heat generating device (e.g. radiator or TV). Ensure the distance from your router to the 4iE is not too great.