How do I fix the error code on my LG washer?
tE Error Code
- Unplug the washer for 10 seconds.
- Plug the washer back in, and press power button. Press the spin speed button until no spin is highlighted.
- Once the washer is drained, restart the washing cycle process.
What are the codes on a LG washer?
Below you’ll find a few of the most common examples of LG washer error codes….Select LG error code on your display:
- FE – Water Overflow Error.
- OE – Drains Slowly.
- IE – Inlet Water Supply.
- UE or UB – Unbalanced Load.
- CL – Child Safety Lock.
- LE – Locked Drive Motor.
- tCL – Tub Clean Cycle.
- dE – Door is Open.
How do you reset a LG washer?
To complete a power reset on your LG washer, unplug the machine from its power source. Wait at least five minutes before plugging the unit’s electrical cord back into the outlet. Unless there are other problems with the machine, the washing machine should reset.
How do I force my LG washer to drain?
If you want to perform a drain-only cycle, turn on your LG washer and press the spin button and then press start. After a few minutes, the cycle will end and your washer should have drained out the water.
What is dE error in LG front load washing machine?
A dE error code indicates that the washer door was unable to lock. This can normally be resolved by performing a simple reset on the washing machine. How to reset the washing machine: Press POWER to turn the washer off.
How do I fix the CE error code on my Kenmore washer?
Unplug the washer for 10 seconds. Plug the washer back in and attempt to run a cycle. If the CE error code persists, close the water tap; and unplug the washer. The unit will require a repair service.
What does CE error code mean on Maytag Bravos washer?
The CE error code indicates that there has been an over-current in the electrical circuit of the motor. It is caused by a short circuit, loose connection, ground fault or power surge. Unplug the washer for 10 seconds. Plug the washer back in and attempt to run a cycle.
What does error code IE mean on Whirlpool washer?
The IE error code indicates a problem with the water supply. Some causes of the IE error code are: Water faucets not being fully opened. Verify that the hoses are not kinked. Make sure there is appropriate water pressure and that the faucets are fully opened.
What does the error code DE2 mean on my Kenmore washer?
The dE2 error code indicates that the washer door is closed, but not locking. Unplug the washer for 10 seconds. Plug the washer back in to ensure that the door is perfectly closed, and restart the cycle.
0