How do I fix Cox error code IA09?

That error code indicates the receiver is not getting a signal. Did you by chance switch outlets in addition to the TV? Try checking the connections from the wall to the box to ensure the line from the wall goes to the cable in port on the back of the box. Let us know the results.

Is there a reset button on Cox cable box?

A screen displays the message We’re resetting your modem… Your modem will reboot. It may take up to ten minutes for the modem to complete the reboot cycle. From the Reset Cable Box screen, tap Begin reset….Solution.

If you want to reboot…	Then…
Your TV receiver(s)	In the My TV section, tap Reset Equipment.

Why is my Cox contour box not working?

Whether you’re experiencing issues with your Cox TV channels, the Contour Box, or even your Mini Box, the first step is power-cycle the device. Turn it off and unplug it, wait for over a minute, and plug it back in. Followed by rebooting your cable box in the TV room.

How do I reset my Cisco cable box?

Reset (power cycle) your receiver by unplugging the power cord from the back of the box. Wait 15 seconds and then plug the power cord back in. Wait up to 20 minutes for the receiver to fully recover and turn it back on.

What does code IA09 mean on Cox cable?

Hi Catgirl, IA09 is an error exclusively for the Contour system, and it indicates a complete lack of signal going into the cable line.

How do I reset my COX cable box?

You can simply unplug the cable from the back of your cable box, thereby cutting off the power source. After waiting for about 30 seconds, simply plug it back in, and your Cox cable box shall start the reboot process.

How do I factory reset my COX router?

RESET – This is recessed to prevent accidental resets and is used to restore all settings to factory defaults. Factory resets result in the loss of all settings. To restore factory defaults, press and hold the indented Reset button for more than 10 seconds or until the front panel LED flashes.

How do you fix a contour box?

Reboot your Contour Stream Player.

1. Turn the TV off.
2. From the wall outlet, unplug the Contour Stream Player power cord.
3. From the Contour Stream Player, unplug the HDMI cable.
4. Plug in the HDMI cable and then the power cord.
5. Turn the TV on.
6. Allow the equipment to restore service. This may take up to 10 minutes.

Does the Contour box turn off?

Most receivers can be put in Power Save mode using the Power button on the front or top of the receiver. This does not turn the TV off. The Wireless 4K Contour Stream Player does not have a power button and can only be powered down through the Device Settings menu.