Can you do PWM without using the PWM module?

Yes Of course. PWM wave of required pulse width can be generated manually by using software.

How do you calculate PWM?

To determine the proportional PWM output voltage, use this formula: (Duty ÷ 256) x 5 V. For example, if Duty is 100, (100 ÷ 256) x 5 V = 1.953 V; PWM outputs a train of pulses whose average voltage is 1.953 V.

Does PWM use timer?

For a PWM timer, the width of the output pulse is like the analog value. For a PWM timer, the output resolution or smallest possible change in the period or width of the output pulse is one period of the clock going into the period counter.

What is PIC16F628A?

PIC16F628A is a CMOS FLASH-based mid-range 8-bit microcontroller that comes with an 18-Pin package, out of which, 16 pins can be used as I/O pins. This microcontroller has 4 Mhz of internal oscillator with 128 bytes of EEPROM data memory, packed with a single Capture/Compare/PWM, and a USART module with 2 comparators.

Why 555 timer is used to generate PWM?

Initially, when the 555 Timer IC is reset, its output is LOW. This will turn ON the internal transistor, which will provide a discharge path for the Capacitor through R2. As the capacitor voltage drops below 1/3 VCC, the output becomes HIGH and transistor is turned OFF.

How do you simulate a PWM signal?

The simplest way to generate a PWM signal is the intersective method, which requires only a sawtooth or a triangle waveform (easily generated using a simple oscillator) and a comparator.

How do you make a PWM signal with a timer?

To create the Left-Aligned PWM, a PWM timer counts downward from a specified maxmimum value, called Period (LOAD) value, to zero. When the timer counts to zero, the Period (LOAD) value will be reloaded to the timer and continue to count down..

Which instruction is applicable to set any bit while performing Bitwise operation settings?

bsf – instruction to set any bit in bitwise operation settings.

Which registers do we use to configure the ports as either input or output?

The ports, often designated as data registers A and B (‘DRA’ and ‘DRB’) each have an associated data direction register (‘DDRA’ and ‘DDRB’), which is used for setting a bit on a port as either an input or an output.